HVAC INSTALLATION SERVICES AGREEMENT
HVAC INSTALLATION SERVICES AGREEMENT
Indiana, United States
This Agreement is made on [date] between [commercial property owner or tenant legal name], of [address] (Customer), and [HVAC contractor legal name], local contractor license or registration number [number], of [address] (Contractor), for the commercial premises at [address] (Site). This Agreement is not for a dwelling or consumer home-improvement project.
1. Installation
Contractor shall furnish and install the heating, ventilation, air-conditioning, controls, ductwork, refrigerant piping, and related items listed in Schedule 1 (System). Work not expressly listed is excluded. Contractor shall perform the installation in a good and workmanlike manner under applicable Indiana building, mechanical, fuel-gas, electrical, energy, fire, environmental, and workplace-safety requirements and manufacturer instructions.
2. Design and existing conditions
Schedule 1 shall identify who is responsible for load calculations, drawings, equipment selection, and professional design. Contractor may rely on accurate Site and design information supplied by Customer but shall promptly report an apparent conflict. Customer shall disclose known hazardous materials, structural limitations, concealed utilities, and operating requirements. Work affected by an unknown condition stops until the parties approve a lawful written change order.
3. Permits and access
Contractor shall obtain the permits and inspections assigned to it in Schedule 1 and maintain required local licenses or registrations. Customer shall provide timely access, clear work areas, available utilities, shutdown windows, and authority to modify the Site. Contractor shall protect occupied areas and coordinate interruptions identified in Schedule 1.
4. Price and payment
Customer shall pay $[amount] according to [deposit, progress, and final payment schedule]. Progress invoices shall identify completed Work, delivered equipment, and approved changes. Undisputed invoices are due within [number] days. Final payment is due after startup, required inspections, and delivery of closeout documents, subject to a reasonable withholding for listed incomplete or defective Work.
5. Changes
No change is binding unless a written change order states the revised scope, price, and schedule and is signed by both parties, except emergency measures reasonably necessary to prevent injury or material damage. A code official's requirement, concealed condition, Customer delay, discontinued equipment, or requested change may justify a change order but does not authorize unpriced work without Customer's written approval.
6. Schedule and commissioning
Contractor shall start by [date] after permits, access, and the required deposit are available and substantially complete by [date]. Contractor receives a reasonable extension for approved changes, Customer delay, inspection or supply delay not caused by Contractor, severe weather, or events beyond reasonable control after prompt notice and mitigation. Contractor shall start up, test, balance to the extent stated in Schedule 1, demonstrate controls, and provide manuals, warranty documents, and inspection approvals.
7. Title, risk, and warranties
Title to paid equipment passes to Customer upon payment; risk of loss passes upon permanent installation except to the extent loss is caused by Contractor. Contractor warrants its workmanship for [number] year(s) after substantial completion and shall correct nonconforming Work reported during that period. Equipment is covered by the manufacturer's warranty identified in Schedule 1. The warranty excludes ordinary maintenance, misuse, unauthorized changes, abnormal utilities, and pre-existing systems not installed by Contractor.
8. Insurance and responsibility
Contractor shall maintain workers' compensation and commercial general and automobile liability coverage in the amounts stated in Schedule 1 and provide certificates before starting. Each party is responsible for injury or property damage to the extent caused by its negligent or wrongful acts. Neither party assumes responsibility for the other's independent negligence.
9. Suspension and termination
Contractor may suspend on [number] days' written notice for an overdue undisputed payment or unsafe or unlawful Site conditions. Either party may terminate for material breach not cured within [number] days after notice. Customer may terminate for convenience and shall pay for conforming Work, properly ordered nonreturnable equipment, and reasonable demobilization, less prior payments.
10. General terms
The parties are independent contractors. Contractor is responsible for its subcontractors. Indiana law governs, and exclusive venue lies in the state or federal courts serving the county of the Site. Notices must be delivered by personal delivery, nationally recognized courier, or confirmed email to [emails]. This Agreement and Schedule 1 are the entire agreement and may be amended only in a signed writing. Invalid terms shall be limited or severed. Counterparts and electronic signatures are effective.
SIGNATURES
CUSTOMER
By: ____________________ Name and title: [name and title] Date: __________
CONTRACTOR
By: ____________________ Name and title: [name and title] Date: __________
SCHEDULE 1 - SYSTEM AND COMMERCIAL SITE
Equipment, model numbers, capacities, controls, and efficiencies: [details]
Drawings, calculations, testing, balancing, commissioning, and included or excluded work: [details]
Permits, responsibility allocation, site access, shutdowns, milestones, and completion date: [details]
Price, payment schedule, warranties, and insurance: [details]
Licensed under CC BY 4.0. Attribution is required when you publish or redistribute this Template or an adapted version to the public. Attribution is not required merely because you use or adapt the Template for your own business or legal purposes, including preparing, negotiating, signing, or exchanging an agreement with a counterparty. License details.